Meter Star Universal LPG Propane Fireplace Fire Pit Gas Control Cock Valve Kit with Thermocouple and Knob Switch, Replacement for Gas Grill,Heater,Fire Pit,Fireplace(3/8" Flare Inlet & Outlet)
Low Working Pressure Max 1/2 PSI(65mbar), CE&CSA tested Main Control Valve In & Out with 5/8"-18UNEF Male Flare thread
Highlights
Length of Thermocoupler 600mm Head Tip M8*1
Platic Black Bakelite Knob Diameter 64mm and "D" Insert for Valve 9.0-9.1mm
Suitable for Low Pressure Repair Control System for Grill, Fire Pit, Fireplace & Heater (max BTU rating: 50000 working pressure 65mbar)
Product Details
Highlights
- Low Working Pressure Max 1/2 PSI(65mbar), CE&CSA tested Main Control Valve In & Out with 5/8"-18UNEF Male Flare thread
- Length of Thermocoupler 600mm Head Tip M8*1
- Platic Black Bakelite Knob Diameter 64mm and "D" Insert for Valve 9.0-9.1mm
- Suitable for Low Pressure Repair Control System for Grill, Fire Pit, Fireplace & Heater (max BTU rating: 50000 working pressure 65mbar)
- Keep The Thermocoupler to be Heated and Push the Valve around 5-10s Then Release Hand (if Flame stops, Ajust the location of Thermocouple tip)
The valve is a low pressure valve with 5/8"-18UNEF Male flare thread on Entrance & Exit Operation Instructions 1). Fix the valve on a plate or board of your grill or fire pit by the head screw and flange. 2). Connect your inlet and outlet hose on inlet and outlet side. (faston it tightly enough in case of gas leakage) 3). Faston the thermocouple nut M8 on the valve end tightly (Check if your valve end thread if 8mm before you buy) 4). Connect thermocouple and end thread well 5). Open gas by correct size knob and push your valve around 5-10s till the thermocouple head is heated enough. 6). Release your hand and it work properly If when you release hand, gas valve shut off again, Please check a. If your thermocouple is always be heated on flame b. If the thermocouple end is well connect with valve c. If the inlet and outlet side well connect with hose you have Possible problems occurs during your use: 1) Valve after turn can not stick during using reason: a. The thermocouple head is not heated in right place, please adjust thermocouple tip position. b. The connection between thermocouple end and valve is not connected tight enough or too tight, please adjust the screw again c. Need to push valve first then turn the spindle and hold for few seconds, it cannot stick immediately may need 10-30Seconds
FAQ
How do I confirm compatibility?
Compare the item number, product images, size, variant option and model information shown on the product page. Contact us before ordering if the part is used with gas, heat, electrical or safety-related equipment.
Do you support bulk purchase?
Small wholesale inquiries are welcome. Send the item number, quantity, destination country and any packaging or delivery requirements, and we will review stock and provide a practical quote.
Related Products
Related replacement parts and accessories that may help complete repair, maintenance or sourcing needs.
【High Performance】This thermopile generator produces over 750mV of heating voltage with a nominal working temperature range of 700-750°C, ensuring efficient operation for gas fireplaces and heating appliances.