69 件商品
Contains: Copper Tube Length 35 Inches, Thermocouple Length 35 Inches, Regular Fire, Ignition Needle Length 35 Inches, Mounting Accessories, As Shown In The Picture All;Safety Pilot Kit With Ignition 2.8*0.5mm Flat Terminal For Igniter & Thermocouple Sensor M8*1 End Thread For Valve 35inch
38" Ignitor Wire & Ceramic Electrode Assembly for many BBQ grill models.Exclusively launch 2 sets of free mounting screws.
Side mounting pushbutton spark generator with attached electrode.
Inlet valve thread M10*1, outlet thread 7/16", Pilot thread M8*1
Wire length: 30cm,Detailed parameters refer to the sample size in the photo，Note that the interface of the ignition needle is round
Weak Current FD4 Dump Safety Switch for gas R≤10 mΩ
Low pressure 65mbar gas valve thermocouple end M8*1
Push Valve with Magnet unit inside (not Turn to run just push)
Low Working Pressure Max 1/2 PSI（65mbar）, CE&CSA tested Main Control Valve In & Out with 5/8"-18UNEF Male Flare thread
Ignition electrode replacement part for heater boilers and high-BTU spark ignition applications.
M10*1 threaded 6.4mm ceramic electrode spark plug with wire 900mm with 2.8x0.5 flat terminal ?With Two M10X1nuts
Sensor activates main control valve after pilot light is lit
2-piece replacement kit: includes two single electrode igniter wires with striker sparkers for ignition repair projects.
Suitable for Lpg propane gas heaters /ovens
Wire length: 25cm on pilot burner & 20cm for spare wire
Total Length: 600mm,wire length 520mm,Head Length: 43mm
This type of thermocouple is used for gas stove single wire, Total Length: 0.8 meter
LP propane water heater pilot burner assembly with pilot thermocouple and tubing, supplied as 1 set.
This type of thermocouple is used for faston type Gas safety magnet unit. Just insert the magnet pin into the thermocouple
One flame pilot burner kit including copper tube